A unique design to:
- Protect the operator
- Minimize mirage
- Promote cooling of the suppressor
- Our 2″ Suppressor Shields will fit suppressors ranging from 1.375″ up to 1.625″ with the same hardware.
- The 2010 model will fit 1.750″ up to 1.900″ primarily designed for the AAC Titan QD (1.850″ x 10″) found on the M-2010 Rifle.
The Suppressor Shield provides an effective buffer against incidental contact with the suppressor, minimizes mirage, and remains solidly in place through heavy recoil.
- The employment of an air gap and carbon fiber reduce the observed surface temperature up to 60%.
- The low thermal conductivity of carbon fiber reduces the “felt” surface temperature to a point that is safer for incidental contact, even at extreme suppressor temperatures.
- Solid top design eliminates mirage along the length of the suppressor by over 80%.
- Carbon fiber’s low thermal transfer rate reduces mirage on all exposed outer surfaces.
COOL THE SUPPRESSOR
- Spacers create an air gap that does not trap heat like a fabric/silicone suppressor wrap.
- Vent design promotes air flow around the suppressor.
- Mechanical attachment holds tight through heat expansion and heavy recoil.
- Suppressor can be removed without removing the shield first.
- Full auto rated.
- NO assembly required
- Use of a single Allan key for installation (10 seconds or less)
SUPPRESSOR SPECIFIC DESIGN
Optimal heat protection and mirage reduction is achieved through months of testing and application specific considerations from 5.56mm to .300WM.